Read Sharp LC-15L1E (serv.man8) Service Manual online
22
LC-15L1E
1. Checking normal startup with terminal software
After entering the command described below, turn on the power again. If the same contents as shown on the
next page appear on the screen, you can confirm that "SS unit" has been started up normally.
next page appear on the screen, you can confirm that "SS unit" has been started up normally.
1. Preparations:
1
PC (with Teraterm communication software installed)
2
Dedicated connector cable
(Checkup procedure)
1
When you are done with the connection as shown above, turn on the power.
2
Several seconds after powering up, the screen will stabilize. Then, hold down Shift key and ~ key simultaneously
for a few seconds to call the prompt.
~
Wireless Center prompt = "$"
TV receiver prompt = "%"
When the sequence ~~~.. appears, press Enter key once to show a single prompt.
TV receiver prompt = "%"
When the sequence ~~~.. appears, press Enter key once to show a single prompt.
3
Enter the following command, and press Enter. "eepw_0x80_0x03" (_ indicates a space.)
4
Turn the power off and then on again.
5
When you have finished checking all display items on the next page, repeat the steps starting from
1
. In the
step
3
, enter "0xFF" instead of "0x03" to put the setting back to a default.
2. Writing and reading the ID code
When either the transmitter or receiver of the SS unit has been replaced, it is necessary to match the ID code
of the transmitter and receiver.
of the transmitter and receiver.
1
Writing the ID code
•
Using the terminal software, call the above screen and key in the following command. Then press the Enter
key.
"idw_
key.
"idw_
~~~~~~~~
" (
~
represents a new ID code.) (_ means a space.)
2
Reading the ID code
•
Using the terminal software, call the above screen and key in the following command. Then press the Enter
key.
"idr"
key.
"idr"
•
Press the Enter key again, and the ID code will appear.
Note: Be sure to enter the ID code assigned to the set in order to avoid confusion with other sets.
Note: Be sure to enter the ID code assigned to the set in order to avoid confusion with other sets.
PC
(with Teraterm
installed)
(with Teraterm
installed)
Wireless Center or
TV receiver
TV receiver
Caution:
"Factory setting terminal" on the
rear face
rear face
(Connection diagram)
Dedicated connector cable
Serial port
φ
2.5 Jack
After starting Teraterm, set to "Serial"
port on initial screen.
port on initial screen.
Example of Teraterm screen (Wireless Center side)
L1 PAL TX Version
MPEG Version 05
Before MPEG CMD
MPEG CMD OK
Before MPEG Standby Cmd
MPEG Standby Cmd OK
Debug Monitor Special Version 1.1
Copyright 2001 SHARP CORPORATION.
All Rights Reserved.
$ ~~~~~~~~
Syntax Error
ERROR
$ eepw 0x80 0x03
OK
$
Click on the first or last page to see other LC-15L1E (serv.man8) service manuals if exist.