LC-15L1E (serv.man6). (6) Removing of major parts - Sharp TV Service Manual (repair manual). Page 2

»

Precautions in reassembling the SS unit

1.  Do not touch by hand the antennas that are on the ANT PWBs to be coupled to the SS unit. Place these

PWBs in position with enough care to keep the antennas in the original shape.

(If by any chance the antenna gets bent or deformed, do not reshape it by hand, nor use the PWB again.

Otherwise communication failure may result.)

2. Insert the connectors of the ANT PWBs from just above tightly to their counterparts on the SS unit. (Do not

insert them slantwise.)

To disconnect the antenna connectors from the SS unit, hold and pull them out vertically. Do not hold the

cables to disconnect. (Otherwise the cables may get broken or the connectors damaged.)

3. Handling the SS unit RF cable

With the SS unit fit in position, dress and secure the RF cable, free of extra load, in its original route.

8. Remove the two lock screws from the operation panel (top cover), and detach the operation panel (top cover)

assembly.

9. Remove the two lock screws from the DC jack PWB and the lock screw from the angle. Detach the DC jack

PWB and the angle.

10. Remove the two lock screws from the R/C, LED PWB, and detach the R/C, LED PWB.
11. Remove the two lock screws from the battery connector PWB, and detach the battery connector PWB.
12. Remove the lock screws one each from the SS (RX) antenna PWBs, and detach the SS (RX) antenna PWBs.
13. Remove the lock screws two each from the speakers, and detach the speakers.

9

10

11

13

13

12

12

8

Battery Connector PWB

Speaker (L)

Speaker (R)

Operation PWB

R/C, LED PWB

Angle

SS(RX) Antenna PWB

SS(RX) Antenna PWB

Top cover

DC Jack PWB