LC-15L1E (serv.man17) - Sharp TV User Guide / Operation Manual. Page 15

* Failure to securely fasten the stand may cause the Wireless

Centre to tip over during use.

* When placing the Wireless Centre upright, make sure to use

the SCART to SCART flat cable (commercially available) for
a connection. The use of this cable can prevent the Wireless
Centre from falling down (See page 44).

Wireless Centre
stand

Rubber foot

Rubber foot

When the TV is turned off with the remote control, the
Wireless Centre is switched to standby (power indicator
is lit red).  (There may be a time lag of about 5 to 6
seconds.)

SIGNAL LEVEL

Transmission

SIGNAL LEVEL 
indicator
(Reception gain)
· Green: 

Communication 
in progress

· Red: 

Difficulty 
in transmission

· Not lit: 

Not communicating

Power indicator
· Green: 

Operation in 
progress 
(when power is on)

· Red: Standby

Power 
button

Antenna 
input
terminal

Antenna 
output
terminal

AV-IN1 (RGB)
(21-pin Euro-SCART)

S-VIDEO

VIDEO

AUDIO (R)

AUDIO (L)

AV-IN3

Factory 
adjustment
terminal

Power input 
DC 12V

Video control 
terminal

AV-IN2 (AV)
(21-pin AV-SCART)

Wireless Centre

Main unit

• The Wireless Centre can be placed horizontally or upright.

• When placing horizontally:

The side on which the rubber feet are attached is the
bottom.

• When placing upright:

Fasten the stand to the bottom of the Wireless Centre with
the screws provided.

We recommend placing the Wireless Centre in an area
where there are no obstructions to impede radio wave
transmission/reception.
(Do not place the Wireless Centre in a box.)