66GF-64 (serv.man18). Split - Part 8 - TV Guide - page 35-44 - Sharp TV User Guide / Operation Manual. Page 2

36

Press the TV GUIDE button  

l

several times until the side

teletext page is shown with all programming for the current channel,
a cursor appears too.

If necessary, Press the Cursor DOWN button 

F

several

times to see the next pages.

If the TV is connected to a VCR with AV LINK function or 
compatible, you can transfer the program data from 
TV GUIDE to TIMER PROGRAMMING Menu to set a late 
recording [

1 Page 40].

Press the Cursor UP/DOWN buttons 

E

/ 

F

to select

the program you wish to record.

Press the GREEN button 

to transfer the program data

from TV GUIDE to TIMER PROGRAMMING Menu.

The TIMER PROGRAMMING Menu with program data is shown on
screen.

Device: Press the Cursor LEFT/RIGHT buttons  

C 

/

I

to

select the controller set (VCR or TV) [

1 Page 41]. 

Press the Cursor UP/DOWN buttons 

E

/ 

F

to select:

Mode: If you want to make additional recordings at the same time

each day or week, use  

C 

/

I

to select Daily or Weekly.

Speed: to change recording speed between Standard-Play (SP) and

Long-Play (LP), by using  

C 

/

I

buttons.

Standard-Play gives the best picture quality; Long-Play provides the
longest recording time.

Press the YELLOW button 

«PROG. VCR» to memorize

the TIMER PROGRAMMING data.

Now the VCR should be manually set for Timer Mode. Refer

to your VCR operation manual for further information.

Press the TV/VIDEO button 

U to clear the on-screen display.

Necessary conditions for the TV GUIDE to operate correctly
The Sharp TV GUIDE works by copying information from the Teletext service for each of the four channels. 
For the TV to perform this function properly:

1. Teletext must be available on all 4 channels.
2

The Teletext for these channels must include pages with hourly schedules of the day's broadcasts.

3. The channels must be set to Pr 1, Pr 2, Pr 3 and Pr 4 on the TV.
4. The TV's real time must be set properly.
5. The TV's configuration must be correct (channel names and teletext paths).

Note: The TV's configuration must be changed only if the channels change the teletext pages where hourly
programming schedules are located.
If the TV cannot copy the data properly from the Teletext, the words "NOT AVAILABLE" appear on menus A and B.
If this happens, display menu C to see the teletext page containing all programming.
To facilitate the teletext scanning process, the automatic data search is also performed periodically while the TV is 
in Stand-By mode.
•  If the TV is turned off with main switch (

¨) the data will be lost.

•  If the TV is turned off with the (

¾ TV) button on the remote control, then if TV is switched on less than 30 

seconds later data will be lost, other wise, data will not be lost.

•  If data is lost, the search will be repeat once the TV is turned back on.

C.- Teletext page with all programming.

A cursor appears too.