66FW-54H (serv.man11). Split - Part 2 - Pages 16- - Sharp TV User Guide / Operation Manual. Page 5

20

Loudness increases the volume of low and high frequency signals according to the current volume setting.

In NORMAL mode keeping the amplitude of the 1 KHz reference frequency constant.
In SPECIAL mode keeping the amplitude of the 2 KHz reference frequency constant.

Press the MENU button  

●

to see the MAIN Menu.

Press the GREEN button 

to see the AUDIO EFFECTS

Press the RED button 

to see the SPEAKERS LEVELS

Press the Cursor UP/DOWN buttons 

E

/ 

F

to select:

Volume, Balance, Loudness mode, Volume centre, Volume surround
or Noise sequencer.

The red point mark indicates the selected item.

Adjust the sound quality to your liking with the Cursor LEFT/RIGHT

buttons 

C 

/

I

.

Note: When the AUDIO MODE is on Bypass, Panorama or Spatial
expander mode, the Volume centre, Volume surround and Noise
sequencer options do not appear.

Select Loudness mode (NORMAL, SPECIAL or OFF) to improve the
sound quality [

].

Select Volume centre to adjust the central volume.

Select Volume surround to adjust the rear loudspeakers volume.

Select Noise sequencer: When Noise sequencer is set to on by 

C 

/

I

buttons, a noise test will be heard through the loudspeakers
(LEFT/RIGHT/CENTRE/SURROUND) [

]. In this mode you can easily

adjust the balances:

• Press the Cursor UP/DOWN buttons 

E

/ 

F

to select: Volume,

Balance, Volume centre, Volume surround or, Volume subwoofer.

• Press the Cursor LEFT/RIGHT buttons 

C 

/

I

to adjust.

• Press the Cursor UP/DOWN buttons 

E

/ 

F

to select Noise

sequencer and press the Cursor LEFT/RIGHT buttons 

C 

/

I

to deactivate

the Noise sequencer.

Press the RED button 

to see the HEADPHONES LEVELS

Balancing the sound levels in two channel stereo is simple and direct, but when three or four channels are used,
the task becomes more difficult. To enable the user to accurately set system balance, a steady test signal is played
in one channel at a time and the levels can be adjusted until they match each other. A mid-frequency noise signal is
used so that it will sound similar from all speakers in the system regardless of size or location.