Read Sharp 56FW-53H Service Manual online
DA100 (50Hz) Chassis – Article for Television Magazine
Page 69 of 80
Sharp Electronics (UK) Limited - March 2003
Service Mode
All adjustments to this chassis, except for focus, are carried out in the service mode.
The service mode is provided to enable the engineer to correctly set up the receiver to the CRT fitted
in the set. Note that these adjustments may vary from one receiver to another.
The service mode is provided to enable the engineer to correctly set up the receiver to the CRT fitted
in the set. Note that these adjustments may vary from one receiver to another.
Entering the Service Mode
To enter the service mode, carry out the following procedure:
1. Connect a test pattern to the antenna terminal.
2. Tune the receiver to this signal.
3. Turn the receiver off using the mains switch.
4. Press volume down and channel up buttons on the front
1. Connect a test pattern to the antenna terminal.
2. Tune the receiver to this signal.
3. Turn the receiver off using the mains switch.
4. Press volume down and channel up buttons on the front
of the receiver at the same time.
5. Keeping these buttons pressed, turn the mains on.
6. When the set starts up it will be in service mode.
7. Release the two buttons.
6. When the set starts up it will be in service mode.
7. Release the two buttons.
Use the channel up and down buttons to move between the options.
Use the volume control buttons to change the data.
To store the data, use the stand-by button on the remote control.
To exit the service mode, turn the receiver off using the mains switch.
When the service mode is entered the following On Screen Display appears
-SERVICE SOFTWARE AND HEXADECIMAL COUNTER DISPLAY:
SW ON XXXX SW OFF XXXX HOURS ON XXXX
The figures displayed in the XXXX locations are hexadecimal representations of the number of times
that particular function has been executed. For example if the hexadecimal number displayed after
SW ON was 0E4A, this would correspond to the receiver being turned on 3658 times.
The following adjustments can be carried out in the service mode:
that particular function has been executed. For example if the hexadecimal number displayed after
SW ON was 0E4A, this would correspond to the receiver being turned on 3658 times.
The following adjustments can be carried out in the service mode:
Horizontal Shift
East West Width
Pin Phase
Pin Amp
Corner Amplitude
Corner Symmetry
Vertical Linearity
Vertical Amplitude
S Correction
Vertical Shift
Red Gain
Green Gain
Blue Gain
Red Cut Off
Green Cut Off
Blue Cut Off
Alter NVM Page
Alter NVM Position
Alter NVM Value
Teletext Mix Mode Contrast
Teletext Contrast
OSD Contrast
DVCO Adjustment (NTSC)
DVCO Adjustment (PAL)
AGC Adjustment
AFT Adjustment
OPC Value
Auto Installation On/Off
Revision 2
Click on the first or last page to see other 56FW-53H service manuals if exist.