32JF-73H (serv.man24) - Sharp TV User Guide / Operation Manual. Page 8

7

■ Auto Installation System

Your television set is provided with an Automatic Installation System
which makes installation easier.
This new system is activated when you turn on the TV for the first
time.

Connect the antenna jack in the antenna input terminal on the
rear side of your TV set. Then connect the TV power cable to a
220 ~ 240V a.c. system.

Press the main power button 

, on the front of the TV set, and

the AUTO INSTALLATION message will appear on the screen.

Put the batteries into the remote control and follow the
instructions on the screen.

If the TV is used with a VCR, turn on the VCR and play back
a pre-recorded tape.

The TV will go through the following steps automatically and
sequentially:

Automatic Channel Sorting System (ACSS): The TV set searches for
frequencies, memorises the channels found, and sorts them
(according to technical criteria) from Pr-01 of the TV, to a maximum of
99 programmes.
This tuning system may take several minutes to perform.

Editing: When the automatic search has been completed, the list of
memorised programmes appears. In this menu, you can change the
order of the channels and change or give the channels a four letter
name.

You may not have to follow this procedure if it has already
been done for you at the establishment where you
purchased your TV. If this is the case, go on to the section
entitled Switching on (page 9).
If you need to repeat the AUTO INSTALLATION, read on.

Press the MENU button 

 to see the MAIN menu.

Press the BLUE button 

to see the TUNE menu.

Press the Channel UP button 

to select AUTO-TUNE.

Press the MENU button 

 to start the AUTO INSTALLATION.

CH

Power indicator

Main power button

VCR