Read Sharp 32HW-53 Specification online
3
32HW-53H
ELECTRICAL SPECIFICATIONS
•Convergence
Static (Centre) .. between any two colours
Dynamic .............. after static equals zero
Dynamic .............. after static equals zero
•Focus ................ High Bi-Potential Electrostatic
•Sweep Deflection ............................... Magnetic
•Picture Intermediate frequency .......... 38.9MHz
•Sound Carrier Trap ........................... 32.9MHz
•Adjacent Sound Carrier Trap ............ 40.9MHz
•Adjacent Picture Carrier Trap ........... 30.9MHz
•Aerial Input Impedance
VHF/UHF ................. 75 ohm Unbalanced
•Tuning Ranges ..... 45.75MHz thru 855.25 MHz
VHF: IR A - J / S1 - S41 CH (Hiperband)
UHF: I21 - I69 CH
CATV Special Channels
UHF: I21 - I69 CH
CATV Special Channels
•White Level
Set brightness control to get total picture tube cathode current of 600 milliammeter under no signal
condition. Maximum necessary correction of each picture tube cathode current to get 8900 de-
grees K-20 MPCD screen temperature should not exceed 15% of its original value.
condition. Maximum necessary correction of each picture tube cathode current to get 8900 de-
grees K-20 MPCD screen temperature should not exceed 15% of its original value.
X=0.290 Y=0.284
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
Specifications are subject to change without prior notice.
•Power Input ...................... 220V-240 Volts AC 50Hz
•Power Consumption
Normal Operation .................................100W
Stand-by Operation ..................................1W
Stand-by Operation ..................................1W
•Audio Power Output Rating (MPO) / Impedance
Internal Left Speaker ...................... 10W, 7
Ω
Internal Right Speaker .................... 10W, 7
Ω
•Speakers
Left / Right ....................................... 6 x 12cm
Display
