Read Sharp XV-Z201E (serv.man11) Service Manual online
27
XV-Z200U/E, XV-Z201E
DT-300
DT-300
UPGRADING THE VERSION
1) Prepare the RS232C cross cable and conversion cable at hand.
1. Connections
Connect the RS232C cross cable to a computer (Windows98 and higher OS), and the conversion cable to the
set.
set.
2. Do not connect the AC power cord yet at this time.
2) Upgrading procedure
1. For upgrading the XV-Z200U/DT-300/XV-Z200E/XV-Z210E, use the "Flash Upgrader" program.
2. Decompress the attached file, and a folder is created.
3. Double-click on "FlashUpgrader.exe", and the following window appears
2. Decompress the attached file, and a folder is created.
3. Double-click on "FlashUpgrader.exe", and the following window appears
4. Click on the "Choose" button, and the following window appears.
28
XV-Z200U/E, XV-Z201E
DT-300
DT-300
5. Click on the arrow mark shown above, and select the decompressed folder.
6. Select "pwSDK.inf" in the folder.
7. Double-click on "pwSDK.inf".
29
XV-Z200U/E, XV-Z201E
DT-300
DT-300
Note:
Do not put checkmark the "Continuous Flash Mode" and "Notify On Completion" boxes, but put checkmark the
"Reset Target After Download" box, all in Options.
Put checkmark the "Flash" box in Modes.
Do not put checkmark the "Continuous Flash Mode" and "Notify On Completion" boxes, but put checkmark the
"Reset Target After Download" box, all in Options.
Put checkmark the "Flash" box in Modes.
8. Click on "Flash".
The above screen shows up to get ready to write the program.
30
XV-Z200U/E, XV-Z201E
DT-300
DT-300
completed.
Do not disconnect the AC cord by at this time . Below windows is underwriting.
Do not disconnect the AC cord by at this time . Below windows is underwriting.
With the writing complete, the following screen shows up.
Click on "Close", and the upgrading ends.
The set may or may not get started itself. But disconnect and reconnect the AC power cord, and get the set started.
After up grade, OSD is in Japanese, Background is set None and Eco mode is ON.
So, change OSD is Englis, Background is set to SHARP and Eco mode is off, (Or, set to "SS5". However, lamp time
is also in this case.)
The set may or may not get started itself. But disconnect and reconnect the AC power cord, and get the set started.
After up grade, OSD is in Japanese, Background is set None and Eco mode is ON.
So, change OSD is Englis, Background is set to SHARP and Eco mode is off, (Or, set to "SS5". However, lamp time
is also in this case.)
