XG-V10XE (serv.man29). - Useful Features Network Functions - Sharp Projector User Guide / Operation Manual. Page 3

This function can be used to set the lamp mode.
The mode can be set to double the effective lamp usage
time.

(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)

1 Press MENU.

2 Press ß/© to select “Options (2)”.

3 Press ∂/ƒ to select “Lamp Mode”, and then

press ©.

4 Press ∂/ƒ to select the desired Lamp Mode.

5 Press ENTER to save the setting.

6 To exit from the GUI, press MENU.

• In “Equal Use” mode, when the projector is used for more than

24 hrs. continuously, it switches in shift of 100 hrs.

1, 6

5

2, 3, 4

Both lamps are used for greater brightness.

Lamp 1 is used.
When lamp 1 burns out, automatically
switches to lamp 2.

Lamp 2 is used.
When lamp 2 burns out, automatically
switches to lamp 1.

Both lamps are used alternatingly.
Switches after every 100 hrs. of use.

It is recommended that the lamp be replaced after approximately 900 cumulative hours of use or when you notice
a significant deterioration of the picture and colour quality. Carefully change the lamp by following the steps on the
next page.
If the new lamp does not light after replacement, take your projector to the nearest Sharp Authorised LCD Projector
Dealer or Service Centre for repair. Purchase a replacement lamp unit (lamp/cage module) of the current type
BQC-XGV10WU/1 from your nearest Sharp Authorised LCD Projector Dealer or Service Centre. Then carefully
change the lamp by following the instructions on the next page. If you wish, you may have the lamp replaced at
your nearest Sharp Authorised LCD Projector Dealer or Service Centre.

• Potential hazard of glass particles if lamp ruptures. In case of lamp rupture, contact your nearest

• Do not remove the lamp cage directly after operation of the projector. The lamp may be extremely