XG-V10XE (serv.man25). - Contents Important Information - Sharp Projector User Guide / Operation Manual. Page 6

The laser pointer on the remote control emits a laser beam from the laser
pointer window. This is a Class II laser which may impair your sight if directed
into the eyes. The two marks shown on the left are caution labels for the laser
beam.

• Do not look into the laser pointer window or shine the laser beam on yourself or

others. (The laser beam used in this product is harmless when directed onto
the skin. However, be careful not to project the beam directly into the eyes.)

• Always use the laser pointer at temperatures between 

Ⳮ5°C and Ⳮ40°C.

• Use of controls or adjustments, or performance of procedures other than those

specified herein may result in hazardous radiation exposure.

See “Replacing the Lamp” on pages 71 and 72.

LAMP REPLACEMENT CAUTION

BEFORE REMOVING THE SC RE W, DISCONNECT
POWER CORD.  HOT SURFACE INSIDE ALLOW
1 HOUR TO COOL BEFORE REPLACING THE
LAMP.  SEE OPERATION MAN UAL.

Potential hazard of glass particles if lamp ruptures. In case of lamp rupture,
contact your nearest Sharp Authorised LCD Projector Dealer or Service Centre
for a replacement.
See “Replacing the Lamp” on pages 71 and 72.

 

Laser pointer
window

CAUTION

POTENTIAL HAZARD OF GLASS
PARTICLES.  SEE  OPERATION MANUAL.

LAMP MAY RUPTURE.

ATTENTION

LAMPE.  DANGER POTENTIEL DE PARTICULES DE
VERRE.  SE  REPORTER AU  MODE  D’EMPLOI.

RUPTURE  POSSIBLE  DE  LA

For minimal servicing and to maintain high image quality, SHARP recommends
that this projector be installed in an area free from humidity, dust and cigarette
smoke. When the projector is subjected to these environments, the lens must
be cleaned more often. As long as the projector is regularly cleaned, use in
these environments will not reduce the overall operation life of the unit. Internal
cleaning should only be performed by a Sharp Authorised LCD Projector
Dealer or Service Centre.

• The exhaust vent, the lamp cage cover and adjacent areas may be extremely

hot during projector operation. To prevent injury, do not touch these areas until
they have sufficiently cooled.

• Allow at least 10 cm of space between the exhaust vent and the nearest wall or

obstruction.

• If the cooling fan becomes obstructed, a protection device will automatically

turn off the projector lamp. This does not indicate a malfunction. Remove the
projector power cord from the wall outlet and wait at least 10 minutes. Then
turn on the power by plugging the power cord back in. This will return the
projector to the normal operating condition.

Ⳮ40˚C

Ⳮ5˚C