Read Sharp XG-V10WE Handy Guide online
Electrical Adjustments
Version 1.1
Issue 04/2006
Issue 04/2006
50
SHARP ELECTRONICS (UK) LTD
PROJECTOR TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
No.
Adjustment Items
Adjustment Conditions
Adjustment Procedures
34
Lens performance checking
Using the set's control switch or the remote
controller, make sure the focus, zoom,
keystone and lens shift actions are as
specified.
controller, make sure the focus, zoom,
keystone and lens shift actions are as
specified.
35
Delivery settings
1. When the S4 delivery settings have
been made, the SET-UP signal is
acceptable.
If the process mode is called up
again, however, the SET-UP signal is
not automatically accepted. In such
case, select Group:
VIDEO1 and Subject: SET UP,
change the SET UP setting from 0 to
1, and exit from the process mode. Or
make the S4 delivery settings again.
been made, the SET-UP signal is
acceptable.
If the process mode is called up
again, however, the SET-UP signal is
not automatically accepted. In such
case, select Group:
VIDEO1 and Subject: SET UP,
change the SET UP setting from 0 to
1, and exit from the process mode. Or
make the S4 delivery settings again.
Make the following settings.
The methods of colour correction adjustment, after LCD panel is replaced.
When not use colour correction system.
When not use colour correction system.
No.
Adjustment Items
Adjustment Conditions
Adjustment Procedures
1
Colour correction Rest
1. Make the following choice.
Group : NOKO
Subject : CC
Group : NOKO
Subject : CC
Make the following setting.
Subject : CC
Setting : 0 (colour correction OFF)
Subject : CC
Setting : 0 (colour correction OFF)
2
Saw-tooth wave Correction
(G), (R)
(G), (R)
1. Feed the grey only RGB colour
signal. (XGA 60Hz)
2. Check for uneven colour spot on
the screen.
3. Make the following choice.
Group : NOKO
Subject : NOKO-G
Choose the subject NOKOR for the R
Colour.
signal. (XGA 60Hz)
2. Check for uneven colour spot on
the screen.
3. Make the following choice.
Group : NOKO
Subject : NOKO-G
Choose the subject NOKOR for the R
Colour.
•
If the colour is irregular, adjust the
setting NOKOG or NOKO-R to
minimise the right-hand and left-hand
colour irregularity.
setting NOKOG or NOKO-R to
minimise the right-hand and left-hand
colour irregularity.
•
If there is no colour irregularity, turn off
the sawtooth correction using SW4201
(green) and SW4202 (red).
the sawtooth correction using SW4201
(green) and SW4202 (red).
Click on the first or last page to see other XG-V10WE service manuals if exist.