XG-V10WE (serv.man7). 10 base-T-board - Sharp Projector Service Manual (repair manual). Page 2

The AN-L10T 10BASE-T board can be installed in an expan-
sion slot on a Sharp projector to control the projector by
10BASE-T interface.
Before installing and using this board, be sure to thoroughly
read the operation manuals accompanying the projector and
Sharp Advanced Presentation Software Professional Edition.

1

10BASE-T port
Use UTP cables for 10BASE-T/100BASE-TX (category5).
When connecting a PC to this board, use a cross type
cable; and when connecting a Hub to this board, use a
straight type cable.

2

LED indicator ( LINK )
Lights up when this board is linked.

3

Status LED ( TX/RX )
Lights up when data is transmitted or received.

Warning
This is a class A product. In a domestic environment this
product may cause radio interference in which case the user
may be required to take adequate measures.

10BASE-T Board installation/uninstallation must be performed
by authorized service personnel only.

A. “Setting Up” the Projector
1. Select “Options” from the menu screen of the projector which

the 10BASE-T board is installed.

2. Select “LAN board”.

Sub menu screen for set up appears.

3. Select “IP Address Set” and enter the address assigned for

this board.

4. Enter the Gateway address and Subnet mask.

• If the IP address, Gateway address or Subnet mask is

unknown, refer to a network administrator.

Enter the IP address as in step A-3.
When setting the “Operation Mode ” to the “Single Projector
Operation Mode ”, enter the address in the  “Projector Setting”
menu, and to the “Multiple Projector Operation Mode ”, enter it
in the “Scan Setting” menu.

If it does not operate correctly, check cable connection and
each setting related to IP address, Gateway address, Subnet
mask, etc.
Use the Sharp Advanced Presentation Software Professional
Edition Version 1.3 or higher.
Download the latest version from our website using the
following URL:
http://www.sharp-world.com/projector/

Standard: Conforms to IEEE802.3
• Connector: RJ-45
• Max. transmission speed: 10 Mbps*
• Max. transmission range: 330 ft. (Appr ox. 100m)*
*Between the hub and this board

• Note that the specifications and the appearance of this

board are subject to change without prior notice for the
purpose of design improvements.

3
2

1

1 10BASE-T BOARD

1 Plotter

7 Screws