Read Sharp XG-P25XE (serv.man7) Service Manual online
XG-P25X
12
REMOVING OF MAJOR PARTS
1. Removing the top cover and lens cover.
1-1. Remove the two screws and detach the lens cover.
1-2. Hold the lens top cover and tilt it up until its back end alone stays hooked. Then slide and detach the top cover.
1-2. Hold the lens top cover and tilt it up until its back end alone stays hooked. Then slide and detach the top cover.
Detach the lens shutter.
(When attaching the lens shutter back in position, match the left (L) and right (R) markings.)
(When attaching the lens shutter back in position, match the left (L) and right (R) markings.)
1
1
2
Top Cover
Lens Shutter
Lens Cover
XG-P25X
13
2. Removing the Intake cover and lamp unit.
2-1. Detach the intake cover.
2-2. Loosen the screw and slide the lamp cover out of position.
2-3. Remove the three screws and lift the lamp unit out of position.
2-2. Loosen the screw and slide the lamp cover out of position.
2-3. Remove the three screws and lift the lamp unit out of position.
3. Removing the rear body.
3-1. Remove the six screws off the terminal board at the back.
3-2. Remove the six screws and detach the rear body.
3-2. Remove the six screws and detach the rear body.
2-1
2-3
3-2
3-2
2-2
3-1
Lamp Cover
Rear Body
Lamp Unit
Intake Cover
XG-P25X
14
4. Removing the top panel.
4-1. Remove the five screws.
4-2. Remove the four screws.
4-3. Press on both sides of the set and undo the hooks. Lift the top body with lens shift knob and disconnect the
4-2. Remove the four screws.
4-3. Press on both sides of the set and undo the hooks. Lift the top body with lens shift knob and disconnect the
connector.
4-1
4-1
4-1
4-2
Lens Shift Knob
Top Body
4-3
4-3
4-3
XG-P25X
15
5. Removing the PWB unit.
5-1. Remove the five screws and detach the PC I/F unit.
5-2. Disconnect the five connectors.
5-3. Remove the two screws and detach the output sub-PWB.
5-4. Disconnect the twelve connectors.
5-5. Take out the hexagonal supports.
5-6. Remove the three screws and detach the output/input PWB assembly.
5-2. Disconnect the five connectors.
5-3. Remove the two screws and detach the output sub-PWB.
5-4. Disconnect the twelve connectors.
5-5. Take out the hexagonal supports.
5-6. Remove the three screws and detach the output/input PWB assembly.
(RP)
(BP)
(GP)
(FF)
(FD)
(LF)
(F)
(AZ)
(SO)
(Q)
(GP)
(D)(FR)
(EA)
(FE)
5-5
5-3
5-6
5-1
5-4
5-2
Output/Input
PWB Ass'y
PWB Ass'y
Output Sub PWB
PC I/F Unit