XG-P20XE (serv.man4). Service Manual Part 1 - Text - p1-35 - Sharp Projector Service Manual (repair manual). Page 33

1. Heat the thermistor using a

dryer.

»

Make sure the “TEMP” is displayed.

1. Receive the PHASE check

pattern signal.

»

Call the VGA/S-VGA/XGA mode and make sure
that the clock, phase, horizontal and vertical
positions can be automatically adjusted.

»

Make sure the keystone correction functions well.

»

In the process mode and select OFF. Make sure that
the off-timer starts with “5” (minutes), counts down
each minute in 1 second, and turns off the set at “0”.

1. Receive the RGB signal.

»

In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.

»

In the process mode nad select L3. Check the bass,
treble and balance.

1. Receive the monoscope

pattern signal.

»

In the process mode and select L2. Check the pic-
ture, brightness and sharpness.

1. Receive the color bar sig-

nal.

»

In the process mode and select L1. Check the color
and tint.

S4

"Factory setting 4" for XU

S3

"Factory setting 3" for XE/XD

Remote controller setting

Process
adjustment

»

Make the following settings.