Read Sharp XG-NV2E (serv.man8) Driver / Update online
27
Adjusting and
Controlling
Multi
2
Set the port to which the projector is connected.
● In 1, check the check box of the COM port to which the projector
is connected.
● To use a LAN, input the IP address in 3, click the “Add” button,
then check the check box in 4.
LAN connections are possible only with models from the XG-V10
series with the optional extension board (AN-L10T) installed.
series with the optional extension board (AN-L10T) installed.
3
Click the “Scan” button.
The connected projectors are identified.
● If projectors with the same IDs are discovered through scanning,
the data for those projectors is displayed in the “Redundant” area.
If this happens, reassign suitable IDs to the projectors.
If this happens, reassign suitable IDs to the projectors.
● The results of scanning are compared with the pre-scanning All
Projector List and the data for projectors that could not be
confirmed as being connected is displayed in the “Missing” area.
confirmed as being connected is displayed in the “Missing” area.
4
Click “OK” if you wish to create an “All Projector List”
based on the results of scanning.
based on the results of scanning.
If you do not wish to create an “All Projector List”, click “Cancel”.
Deleting the set IP address
1
Select the IP address to be deleted in 4
4
4
4
4.
2
Click the “Delete” button.
Click on the first or last page to see other XG-NV2E (serv.man8) service manuals if exist.