XG-MB70X (serv.man35). Complete - Sharp Projector User Guide / Operation Manual. Page 6

The cooling fan in this projector continues to run for about 90 seconds after the projector enters the standby mode.
During normal operation, when putting the projector into standby mode always use the STANDBY button on the
projector or on the remote control. Ensure the cooling fan has stopped before disconnecting the power cord.
DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD.
FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE.

See “Replacing the Lamp” on page 

.

This projector utilizes tin-lead solder, and a pressurized lamp containing a small amount of mercury. Disposal of
these materials may be regulated due to environmental considerations. For disposal or recycling information,
please contact your local authorities or, if you are located in the United States of America, the Electronic Industries
Alliance: www.eiae.org .

LAMP REPLACEMENT WARNING :

TURN OFF THE LAMP AND DISCONNECT 
POWER CORD BEFORE OPENING THIS 
COVER. HOT SURFACE INSIDE. 
ALLOW 1 HOUR TO COOL BEFORE REPLACING THE LAMP. 
REPLACE WITH SAME SHARP LAMP UNIT MODEL 
AN-MB70LP ONLY.

HIGH PRESSURE LAMP : 

RISK OF EXPLOSION. 

POTENTIAL HAZARD OF GLASS PARTICLES IF LAMP HAS 
RUPTURED. HANDLE WITH CARE. SEE OPERATION MANUAL.

SERVICEMAN-WARNING :

 USE RADIATION EYE AND 

SKIN PROTECTION DURING SERVICING.

AVERTISSEMENT CONCERNANT LE

  

REMPLACEMENT DE LA LAMPE :

ETEINDRE LA LAMPE ET DEBRANCHER LE CORDON 
D’ALIMENTATION AVANT D’OUVRIR LE COUVERCLE. 
L’INTERIEUR DU BOITIER ETANT EXTREMEMENT CHAUD, 
ATTENDRE 1 HEURE AVANT DE PROCEDER AU 
REMPLACEMENT DE LA LAMPE. NE REMPLACER QUE 
PAR UNE LAMPE SHARP DE MODÈLE AN-MB70LP.

LAMPE A HAUTE PRESSION : 

RISQUE 

D’EXPLOSION. DANGER POTENTIEL DE PARTICULES DE 
VERRE EN CAS D’ECLATEMENT DE LA LAMPE. 
A MANIPULER AVEC PRECAUTION.
SE REPORTER AU MODE D’EMPLOI.

AVERTISSEMENT – REPARATEUR :

 SE PROTEGER LES 

YEUX ET LA PEAU DES RADIATIONS LORS DES REPARATIONS.

This SHARP projector uses a DMD panel. This very sophisticated panel contains 786,432 pixels micromirrors. As
with any high technology electronic equipment such as large screen TVs, video systems and video cameras, there
are certain acceptable tolerances that the equipment must conform to.
This unit has some inactive pixels within acceptable tolerances which may result in inactive dots on the picture
screen. This will not affect the picture quality or the life expectancy of the unit.

• DLP

TM

 (Digital Light Processing) and DMD

TM

 (Digital Micromirror Device) are trademarks of Texas Instru-

ments, Inc.

• Microsoft

®

 and Windows

®

 are registered trademarks of Microsoft Corporation in the United States and/or

other countries.

• PC/AT is a registered trademark of International Business Machines Corporation in the United States.
• Adobe

®

 Reader

®

 is a trademark of Adobe Systems Incorporated.

• Macintosh

®

 is a registered trademark of Apple Computer, Inc. in the United States and/or other countries.

• All other company or product names are trademarks or registered trademarks of their respective compa-

nies.

XG-MB70X_E_P01_03.p65

2004.8.6, 11:56 AM

2