Read Sharp XG-MB70X (serv.man34) User Guide / Operation Manual online
-67
Appendix
Optional
accessory
Lamp unit
AN-MB70LP
AN-MB70LP
Removing and Installing
the Lamp Unit
the Lamp Unit
Info
• Ensure the lamp unit is removed using the
handle. Ensure the glass surface of the
lamp unit or the inside of the projector are
not touched.
lamp unit or the inside of the projector are
not touched.
• To avoid injury to yourself and damage to
the lamp, ensure to carefully follow the
steps below.
steps below.
• Do not loosen other screws except for the
lamp unit cover and lamp unit.
1
Press
on the projector or
on the remote control to put
the projector into standby mode.
• Wait until the cooling fan stops.
Warning!
• Do not remove the lamp unit from the
projector right after use. The lamp and
parts around the lamp will be very hot
and may cause burn or injury.
parts around the lamp will be very hot
and may cause burn or injury.
2
Disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3
Remove the lamp unit cover.
• Turn the projector over. Loosen the user
service screw (1) that secures the lamp
unit cover. Pressing the tab, remove the
lamp unit cover (2).
unit cover. Pressing the tab, remove the
lamp unit cover (2).
1
2
User service screw
(for lamp unit cover)
(for lamp unit cover)
Tab
Tab
AC socket
STANDBY button
XG-MB70X_E_P63_69.p65
2004.8.6, 0:01 PM
67
Click on the first or last page to see other XG-MB70X (serv.man34) service manuals if exist.