XG-C40XE (serv.man3). Service manual section 2 - Additional and amended information - Sharp Projector Service Manual (repair manual). Page 8

1. Receive the colour bar sig-

nal.

»

In the process mode and select L1. Check the col-
our and tint.

1. Receive the monoscope pat-

tern signal.

»

In the process mode and select L2. Check the pic-
ture, brightness and sharpness.

»

In the process mode nad select L3. Check the bass,
treble.

1. Receive the RGB signal.

»

In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.

»

In the process mode and select OFF. Make sure that
the off-timer starts with “5” (minutes), counts down each
minute in 1 second, and turns off the set at “0”.

1. Heat the thermistor using a

dryer.

»

Make sure the “TEMP” is displayed.

1. Receive the PHASE check

pattern signal.

»

Call the VGA/SVGA/XGA/SXGA mode and make
sure that the clock, phase, horizontal and vertical
positions can be automatically adjusted.

»

Make sure the keystone correction functions well.

»

Make the following settings.

S3

“Factory setting 3”(XG-C40XE1)

S4

“Factory setting 4”(XG-C40XU1)

Process
adjustment

Remote controller setting