Read Sharp PG-M20X (serv.man25) User Guide / Operation Manual online
Basic Operation
-29
"On-screen Display (Example)
➝
➝➝
Using Analog
RGB
RGB
Using
Component
Component
INPUT 2 Mode
Using S-Video
Using S-Video
INPUT 3 Mode
Using Video
Using Video
3
Press
,
or
on the
remote control to select the
INPUT Mode.
INPUT Mode.
• Pressing
on the projector switches
the inputs in the following order:
→ INPUT 1 → INPUT 2 → INPUT 3
Note
• When no signal is received, “NO
SIGNAL” will be displayed. When a
signal that the projector is not pre-
set to receive is received, “NOT
REG.” will be displayed.
signal that the projector is not pre-
set to receive is received, “NOT
REG.” will be displayed.
About the INPUT Modes
Used for projecting im-
ages from equipment that
sends RGB signals or
Component signals con-
nected to the DVI-DIGI-
TAL/ANALOG input port.
ages from equipment that
sends RGB signals or
Component signals con-
nected to the DVI-DIGI-
TAL/ANALOG input port.
Used for projecting im-
ages from equipment
connected to the S-
VIDEO input terminal.
ages from equipment
connected to the S-
VIDEO input terminal.
Used for projecting im-
ages from equipment
connected to the VIDEO
input terminal.
ages from equipment
connected to the VIDEO
input terminal.
INPUT 1
(RGB/
Component)
(RGB/
Component)
INPUT 2
(S-Video)
(S-Video)
INPUT 3
(Video)
(Video)
INPUT 1 Mode
Using
DVI digital
4
Press
or
on the remote
control to adjust the volume of
the speaker.
the speaker.
Note
• Pressing
will raise the volume.
Pressing
will lower the volume.
• On the projector, the volume can be
adjusted by pressing
or
.
•
,
on the projector operate
as cursor buttons (
,
) when
selecting setup or adjustment
functions while adjusting menus or
the lens.
functions while adjusting menus or
the lens.
VOLUME
buttons
buttons
Click on the first or last page to see other PG-M20X (serv.man25) service manuals if exist.