Read Sharp PG-M15 (serv.man3) Service Manual online
13
PG-M15X
PG-M15S
AN-M15T
REMOVING OF MAJOR PARTS
Tools required
1. Philips screw driver (Size : 1, 2)
2. Nut driver (2.5mm)
3. Ball end hexagonal driver (5.0mm)
2. Nut driver (2.5mm)
3. Ball end hexagonal driver (5.0mm)
1. Disassemble Top Cover Module, Main PWB Unit and DC to DC PWB Unit
1-1. Remove four screws on Bottom Cover. (Refer to Step 1, 2.)
Step 1
Step 2
1-1
14
PG-M15X
PG-M15S
AN-M15T
1-3
1-4
IR PWB Unit Cover
IR PWB Unit
1-2. Lift up Top Cover and unplug two wires connected to IR PWB Unit and Main Unit. (Refer to Step 3~5.)
1-3. Remove Top Cover.
1-4. Remove one screw to take off IR PWB Unit and IR PWB Unit Cover.
1-5. Remove four D-SUB shafts from the D-SUB Terminals to take off Terminal Sheet. (Refer to Step 6~7.)
1-3. Remove Top Cover.
1-4. Remove one screw to take off IR PWB Unit and IR PWB Unit Cover.
1-5. Remove four D-SUB shafts from the D-SUB Terminals to take off Terminal Sheet. (Refer to Step 6~7.)
Step 6
Step 7
Terminal sheet
1-5
Step 3
Step 4
Step 5
1-2
1-2
15
PG-M15X
PG-M15S
AN-M15T
2. Disassemble Optical Engine Module
2-1. Remove 4 screws from main PWB unit.
2-2. Using a ball end hexagonal driver, loosen 2 screws holding terminal sheet holder.
2-2. Using a ball end hexagonal driver, loosen 2 screws holding terminal sheet holder.
(approx. 4 rotation)(Step 8.)
2-3. Place a tool in between main PWB unit and formatter PWB unit and disconnect the connector. (Step 9.)
2-4. Pull the main unit outwards and remove main PWB unit. (Step 10,11.)
2-4. Pull the main unit outwards and remove main PWB unit. (Step 10,11.)
DC to DC PWB Unit
2-1
2-1
Step 8
Step 9
2-2
2-3
Step 10
Step 11
2-4
16
PG-M15X
PG-M15S
AN-M15T
Cut three cable tie
from Optical Engine
Module.
from Optical Engine
Module.
Step 12
Step 13
Unplug three
Connecting Cords
of DC to DC PWB Unit
Connecting Cords
of DC to DC PWB Unit
2-5
2-5. Remove one screw of DC to DC PWB Unit Holder, unplug three Connecting Cords, and then detach DC to
DC PWB Unit.
(Step 12,13.)
(Step 12,13.)
2-6. Remove push bar, push bar spring, and rubber. (refer to step 14~16.)
Step 14
Step 15
Step 16
2-6
2-6