PG-M15 (serv.man11). PGM15SE XE - Sharp Projector User Guide / Operation Manual. Page 16

1 Connect one end of the supplied computer RGB cable

using the supplied DVI-Analog to VGA adaptor to the
DVI-DIGITAL/ANALOG INPUT 1 port on the projector,
or connect the DVI side of the supplied DVI-Analog to
VGA cable to the DVI-DIGITAL/ANALOG INPUT 1 port
on the projector.

2 Connect the other end of the computer RGB cable or

the VGA side of the DVI-Analog to VGA cable

 

to the

computer. Secure the connectors by tightening the
thumb screws.

3 To use the built-in audio system, connect one end of

the supplied PC audio cable to the AUDIO INPUT
terminal on the projector.

4 Connect the other end to the audio output terminal on

the computer.

• Before connecting, be sure to turn both the projector and the

computer off. After making all connections, turn the projector
on first. The computer should always be turned on last.

• Please read the computer’s operation manual carefully.
• Refer to page 53 “Computer Compatibility Chart” for a list of

computer signals compatible with the projector. Use with
computer signals other than those listed may cause some of
the functions not to work.

• A Macintosh adaptor may be required for use with some

Macintosh computers. Contact your nearest Sharp Authorized
Projector Dealer or Service Center.

Computer RGB cable

PC audio cable

DVI-Analog to VGA cable

DVI-Analog to VGA
adaptor

PC audio cable

• This projector is compatible with VESA-standard DDC 1/DDC 2B. The projector and a VESA DDC compatible

computer will communicate their setting requirements, allowing for quick and easy setup.

• Before using the “Plug and Play” function, be sure to turn on the projector first and the connected computer last.

• The DDC, Plug and Play function of this projector operates only when used in conjunction with a VESA DDC compatible

computer.

When connecting the projector to a compatible computer other than an IBM-PC (VGA/SVGA/XGA/SXGA) or
Macintosh (i.e. Workstation), a separate cable may be needed. Please contact your dealer for more information.

• Connecting computers other than the recommended types may result in damage to the projector, the computer, or both.

Computer RGB cable

DVI-Analog to VGA adaptor

1

2

DVI-Analog to VGA cable

3

4

Projecting the image
When connecting with this method,
press INPUT on the remote control or
the projector and select the input signal
type to INPUT 1 Computer/Analog
RGB.