Read Sharp PG-C30XE (serv.man4) Service Manual online
27
PG-C30XE
No.
Adjusting point
Adjusting conditions
Adjusting procedure
30
RGB
performance
check
performance
check
1. Receive the RGB signal.
»
In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
31
Off-timer
performance
check
performance
check
»
In the process mode and select OFF. Make sure that
the off-timer starts with “5” (minutes), counts down each
minute in 1 second, and turns off the set at “0”.
the off-timer starts with “5” (minutes), counts down each
minute in 1 second, and turns off the set at “0”.
32
Thermistor
performance
check
performance
check
1. Heat the thermistor using a
dryer.
»
Make sure the “TEMP” is displayed.
33
Automatic
synchronization
synchronization
1. Receive the PHASE check
pattern signal.
»
Call the VGA/SVGA/XGA/SXGA mode and make
sure that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
sure that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
34
Keystone
correction
performance
check
correction
performance
check
»
Make sure the keystone correction functions well.
35
Factory settings
»
Make the following settings.
Process
adjustment
adjustment
Remote controller
setting
setting
S3
“Factory setting 3”
Click on the first or last page to see other PG-C30XE (serv.man4) service manuals if exist.