Read Sharp PG-C30XE (serv.man14) User Guide / Operation Manual online
17
Adjusting and
Controlling
● Adjustments can still be made from the RS-232C Control utility
regardless of the difference in settings in the projector’s menu.
● If you move to RS-232C Control during Presentation Transfer,
Capture & Transfer or Gamma Correction, Sharp Advanced
Presentation Software automatically confirms the adjustments on
the projector and shows them in the “RS-232C Control” window as
default settings.
Presentation Software automatically confirms the adjustments on
the projector and shows them in the “RS-232C Control” window as
default settings.
● Also when you change the sheet of the “RS-232C Control” window
to proceed to the other projector adjustment, this confirmation is
performed. In this case, it will repeat at regular intervals afterwards
and the “RS-232C Control” window may show the settings on the
projector.
performed. In this case, it will repeat at regular intervals afterwards
and the “RS-232C Control” window may show the settings on the
projector.
● The Automatic Power Shutoff function will not operate when
performing RS-232C Control, although you turn “Auto Power Off”
ON in the
ON in the
“Options”
sheet. This function operates during
Presentation Transfer, Capture & Transfer, or Gamma Correction.
● To use RS-232C Control after transferring images in “Presentation
Transfer”,“Capture
&
Transfer” or “Quick Transfer”, switch
the input
in “Input Select”
(page 18)
.
Before Adjusting
Please connect a serial (RS-232C) cable to the projector and the PC
(page 6)
, select the correct COM Port on the PC, then proceed with
RS-232C Control.
1
Select the “RS-232C Control” mode.
See section “Opening Modes”
(page 12)
.
w The “RS-232C Control” window will open.
2
Click the tab of the sheet including your desired
adjustment controller.
adjustment controller.
Click on the first or last page to see other PG-C30XE (serv.man14) service manuals if exist.