PG-A10XA (serv.man2). p37 - Sharp Projector Service Manual (repair manual). Page 6

Read Sharp PG-A10XA (serv.man2) Service Manual online

6
PG-A10X-A
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
1
2
Lamp
Reflector
Comme de petites quantités de radiation UV sont
émises par une ouverture entre les ventilateurs as-
pirants, il est recommandé de placer le capuchon de
l’optique optionnelle sur l’ouverture pendant l’entretien
pour éviter une exposition des yeux et la peau.
Since small amounts of UV-radiation are emitted
from an opening between the exhaust fans, it is rec-
ommended to place the cap of the optional lens on
the opening during servicing to avoid eye and skin
exposure.
DANGER !  –– Never turn the power on without the
lamp to avoid electric-shock or damage of the devices
since the stabilizer generates high voltages at its start.
UV-RADIATION PRECAUTION (Continued)
Lamp Replacement
Note:
Since the lamp reaches a very high temperature during
units operation replacement of the lamp should be
done at least one hour after the power has been turned
off.  (to allow the lamp to cool off.)
Installing the new lamp, make sure not to touch the
lamp (bulb) replace the lamp by holding its reflector
2
.
[Use original replacement only.]
DANGER !  –– Ne jamais mettre sous tension sans la
lampe pour éviter un choc électrique ou des
dommages des appareils car le stabilisateur génère
de hautes tensions à sa mise en route.
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
123456789012345678901234567890121234567890123456
1
2
Remplacement de la lampe
Remarque:
Comme la lampe devient très chaude pendant le
fonctionnement de l’unité, son remplacement ne doit
être effectué au moins une heure après avoir coupé
l’alimentation (pour permettre à la lampe de refroidir).
En installant la nouvelle lampe, s’assurer de ne pas
toucher la lampe (ampoule).  Remplacer la lampe en
tenant son réflecteur  
2
.
[N’utiliser qu’un remplacement d’origine.]
PRECAUTION POUR LES RADIATIONS UV (Suite)
Lampe
Reflecteur
Page of 37
Display

Click on the first or last page to see other PG-A10XA (serv.man2) service manuals if exist.