Read Sharp PG-A10X (serv.man34) User Guide / Operation Manual online
-26
Image Projection
▼Keycode input box
Basic Procedure
Connect the required external equipment to the pro-
jector before carrying out the following procedures.
jector before carrying out the following procedures.
Info
• The language preset at the factory is English.
If you want to change the on-screen display to
another language, reset the language accord-
ing to the procedure on page
another language, reset the language accord-
ing to the procedure on page
28
.
1
Plug the power cord into the wall
outlet.
outlet.
• The power indicator illuminates red, and
the projector enters standby mode.
2
Press
on the projector or
on the remote control.
• The power indicator illuminates green.
After the lamp replacement indicator illu-
minates and the warming up message
on the display disappears, the projector
is ready to start operation.
minates and the warming up message
on the display disappears, the projector
is ready to start operation.
Note
• The lamp replacement indicator illumi-
nates, indicating the status of the lamp.
Green: The lamp is ready.
Blinking in green: The lamp is warming
Blinking in green: The lamp is warming
up and shutting down.
Red: The lamp should be replaced.
• If the power is turned off and immedi-
ately switched on again, the lamp re-
placement indicator may take some
time to illuminate.
placement indicator may take some
time to illuminate.
• When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds af-
ter the power has been turned on, and
then transmit the commands.
puter, wait for at least 30 seconds af-
ter the power has been turned on, and
then transmit the commands.
• The projector cannot be operated while
the warming up message is displayed.
• When “Anti-Theft” (see page
48
) is set,
the keycode input box will appear. Enter
the keycode.
the keycode.
Note
• When entering the keycode, press the
buttons previously set on the projec-
tor or the remote control.
tor or the remote control.
• For details about the Anti-Theft func-
tion, refer to “Anti-Theft (Setting the
Anti-Theft)” on page
Anti-Theft)” on page
48
.
Power ON
button
button
INPUT buttons
AV MUTE button
Volume
buttons
Lamp
replacement
indicator
replacement
indicator
Power
indicator
indicator
INPUT
button
button
Volume
buttons
buttons
Power ON
button
Power OFF
button
▼Keycode input box
▼Warming up message
Click on the first or last page to see other PG-A10X (serv.man34) service manuals if exist.