Read Sharp AN-W9Z User Guide / Operation Manual online
GB
2
Mounting the Lens
1
Remove the wide conversion lens
from its original box. Put the screw
thread of the wide conversion lens
and the projector lens together.
from its original box. Put the screw
thread of the wide conversion lens
and the projector lens together.
2
Fix the focus ring of the projector
manually. Then turn the wide
conversion lens clockwise slowly.
(NOTE: Mounting the lens when
the screw thread of both lenses
is incorrectly set may cause
damage. Make sure that the
screw thread of both lenses is set
correctly and then turn the wide
conversion lens slowly.)
manually. Then turn the wide
conversion lens clockwise slowly.
(NOTE: Mounting the lens when
the screw thread of both lenses
is incorrectly set may cause
damage. Make sure that the
screw thread of both lenses is set
correctly and then turn the wide
conversion lens slowly.)
3
When the wide conversion lens has been mounted, set
the part for preventing the lens from falling. (See the
“Mounting the part for preventing the lens from falling”
section in this manual.)
the part for preventing the lens from falling. (See the
“Mounting the part for preventing the lens from falling”
section in this manual.)
Mounting the part for preventing the
lens from falling
lens from falling
1
Set the part for preventing the
lens from falling as shown on the
illustration. (Make sure that the
part is attached to the outer ditch
of the focus ring on the projector.)
lens from falling as shown on the
illustration. (Make sure that the
part is attached to the outer ditch
of the focus ring on the projector.)
2
Attach the two screws (included)
using the included screwdriver.
using the included screwdriver.
Projector lens
Wide conversion lens
The part for preventing
the lens from falling
(included)
the lens from falling
(included)
AN_W9Z(E)#p02-05.pm6
01.12.27, 1:12 PM
2
Click on the first or last page to see other AN-W9Z service manuals if exist.