MX-TM10 (serv.man11). All Sections (UK Modified) - Sharp Copying Equipment Service Manual (repair manual). Page 20

2

2

2-8

2-8

Technology > Controls > Registration operation

Technology > Controls > Registration operation

Registration operation

The sequence of registration operation is described below. 
1. Drive the front estrangement motor (M103) before the center bound booklet is fed from the 
saddle unit to separate the inlet roller (lower).
2. Drive the feed motor (M101) when the booklet passed from the saddle unit reaches the 
inlet sensor (S101). 
3. When the booklet reaches the inlet roller, drive the press motor (M105) and separate the 
press roller (upper). Then drive the front estrangement motor (M103) and press and feed the 
booklet with the inlet roller. 
4. When the booklet reaches the trimming position, drive the rear estrangement motor (M104) 
and separate the paper delivery roller (upper). 
Also, drive the registration motor (M102) and move the registration unit to the registration 
start position. At the same time, drive the stopper solenoid (SL101) and lift the registration 
guide. 
5. Feed the booklet to the registration start position and drive the front estrangement motor to 
separate the inlet roller (lower). 
6. After separating the inlet roller, drive the registration motor (M102) to register. 

Paper delivery roller (upper)

Front estrangement

motor (M103)

Inlet roller (lower)

Inlet sensor (S101)

Rear estrangement

motor (M104)

Feed motor (M101)

Press motor (M105)

Press roller (upper)

F-2-9

Registration guide

Registration motor (M102)

F-2-10