MX-RB15 (serv.man3). MX-RB15 Installation Manual - Sharp Copying Equipment Service Manual (repair manual). Page 3

MX-7040N  MX-RB15 (CURL CORRECTION UNIT)  16 – 3

NOTE: When the adjuster bolt is turned counterclockwise, the

height is decreased. When turned clockwise, the height is
increased.

NOTE: For the height and tilt adjustment, use the three adjuster

bolts under the unit.

Turn the adjustment nuts of the casters with a wrench in the arrow
direction to adjust the height. (When turning the adjustment nut one
rotation, the height of the curl correction unit is changed by about
1.75mm.)
• To increase the curl correction unit height, turn the nut in the

direction [A].

• To decrease the curl correction unit height, turn the nut in the

direction [B].

NOTE: Use the wrench attached to the finisher.

1)

Use adjuster bolt (1) to adjust the height so that the center of
the hole for the unit fixing screw in the F side is aligned with
the center marking-off line. 

2)

Use adjuster bolt (2) to adjust the height so that the center of
the hole for the unit fixing screw in the R side is aligned with
the center marking-off line. 

3)

Use adjuster bolt (3) so that the clearance between the
machine and the unit becomes uniform.

1)

Fix the unit to the machine with the step screws (Packed
items).

1)

Connect the three connectors of the unit to the machine, and
fix with the screws.

Ԙ

Ԛ

ԙ