Read Sharp MX-RB14 (serv.man2) Service Manual online
MX-7040N MX-6240N/7040N (MAIN UNIT) 2 – 11
8) Open the right lower door.
9) Remove the B5 size regulation plate.
9) Remove the B5 size regulation plate.
10) Install the B5 size regulation plate to the tray 1.
11) Attach the A4 size regulation plate to inner side of the r ight
lower door.
12) Close the right lower door.
13) Close the tandem paper feed tray.
13) Close the tandem paper feed tray.
c. Tray 3, Tray 4
1) Pull out the paper tray.
1) Pull out the paper tray.
Gently pull the tray out until it stops.
If paper remains in the tray, remove it.
If paper remains in the tray, remove it.
2) Adjust the guide plates A and B by squeezing their lock levers
and sliding them to match the vert ical and horizontal dimen-
sions of the paper to be loaded.
The guide plates A and B are slidable. Slide each guide plate
The guide plates A and B are slidable. Slide each guide plate
while squeezing its lock lever.
J. Specifications setup
Used to set the specifications with SIM26 according to the cus-
tomer's request.
To customize the following items after completion of the destination
setup, change the set values.
SIM No
Content
26
6
Used to set the destination.
SIM No
Content
26
2
LCC paper size setting
3
Used to set the auditor specification mode.
5
Used to set the count mode of the total counter and
the maintenance counter.
18
Used to set YES/NO of the toner save mode (Only
in UK and Japan versions)
* For other destination versions, this setup is
made by the user program.
52
Used to set YES/NO of counting when non-print
paper is passed through each counter.
53
Used to set YES/NO of user calibration permission.
65
Used to set the limit number of sheets for stapling.
A
B
Click on the first or last page to see other MX-RB14 (serv.man2) service manuals if exist.