Read Sharp MX-RB10 Service Manual online
MX-RB10 MAINTENANCE 3 – 3
3. Disassembly and assembly of each
unit
A. Inlet port roller (Drive), inlet port rear roller
(Drive), paper exit front roller (Drive), paper
exit roller (Drive)
exit roller (Drive)
1)
Remove the paper pass unit.
2)
Open the upper guide unit, and clean the inlet port roller
(Drive), inlet port rear roller (Drive), paper exit front roller
(Drive), and the paper exit roller (Drive).
(Drive), inlet port rear roller (Drive), paper exit front roller
(Drive), and the paper exit roller (Drive).
If the interface reverse path solenoid is removed, the adjustment is
required at the installation.
required at the installation.
Adjust so that the distance between the lower guide and the upper
guide flapper is 23mm with the solenoid plunger pushed in. Install
the interface reverse path solenoid.
guide flapper is 23mm with the solenoid plunger pushed in. Install
the interface reverse path solenoid.
No.
Name
1
Inlet port roller (Drive)
2
Inlet port rear roller (Drive)
3
Paper exit front roller (Drive)
4
Paper exit roller (Drive)
4
1
3
2
23mm
Click on the first or last page to see other MX-RB10 service manuals if exist.