Read Sharp MX-PNX1D (serv.man10) Service Manual online
MX-FNX1/MX-PNX1 ADJUSTMENTS 8 – 2
[Screen]
3
Flapper solenoid adjustment
When the flapper solenoid is disassembled, an adjustment is
required when assembling. (Disassembly and assembly: Refer to
6-2.)
required when assembling. (Disassembly and assembly: Refer to
6-2.)
4
Punch home position adjustment
In case the punch unit comes out of order and does not function,
turn the dial to make the punch align to the home position. By mak-
ing the punch align to the home position, only the paper feed
comes possible.
turn the dial to make the punch align to the home position. By mak-
ing the punch align to the home position, only the paper feed
comes possible.
D
STAPLE
FRONT
FRONT
Staple binding
position
adjustment
(One position,
front)
position
adjustment
(One position,
front)
0.155mm
Large value: The
distance between the
staple position and the
paper edge becomes
longer.
Small value: The
distance between the
staple position and the
paper edge becomes
shorter.
distance between the
staple position and the
paper edge becomes
longer.
Small value: The
distance between the
staple position and the
paper edge becomes
shorter.
E
STAPLE
BOTH
BOTH
Staple binding
position
adjustment (2
positions,
center)
position
adjustment (2
positions,
center)
0.155mm
Large value: The
staple position is
shifted to the bottom
from the center.
Small value: The
staple position is
shifted to the front
from the center.
staple position is
shifted to the bottom
from the center.
Small value: The
staple position is
shifted to the front
from the center.
F
STAPLE
PITCH
PITCH
Staple binding
position
adjustment (2
positions, pitch)
position
adjustment (2
positions, pitch)
0.155mm
Large value: The pitch
of 2 positions
becomes greater.
Small value: The pitch
of 2 positions
becomes smaller.
of 2 positions
becomes greater.
Small value: The pitch
of 2 positions
becomes smaller.
G
PUNCH
CENTER
CENTER
Punch center
adjustment
adjustment
0.1441mm
Large value: The hole
position is shifted to
the bottom from the
center.
Small value: The hole
position is shifted to
the front from the
center.
position is shifted to
the bottom from the
center.
Small value: The hole
position is shifted to
the front from the
center.
H
PUNCH
HOLE
HOLE
Punch hole
position
adjustment
position
adjustment
0.2584mm
Large value: The
distance between the
hole position and the
paper rear edge
becomes shorter.
Small value: The
distance between the
hole position and the
paper rear edge
becomes longer.
distance between the
hole position and the
paper rear edge
becomes shorter.
Small value: The
distance between the
hole position and the
paper rear edge
becomes longer.
Item
Display
Item
Variation
Change direction
0
A:
A: 10
; FRONT ADJUST
B: 10
; REAR ADJUST
C:100
; STAPLE REAR
D:100
; STAPLE FRONT
SIMULATION NO.03-10
FINISHER ADJUSTMENT
10
[
2~ 18 ]
OK
TEST
CLOSE
HOME
Display