MX-PEX2 (serv.man3). Updated November 2006 - Sharp Copying Equipment Service Manual (repair manual). Page 6

MX-PEX2  Installation in MX-5500N/6200N/7000N  3 – 1

MX-PEX2

Service Manual

 

<Note before installation>
* Start installation after checking that the LINE indicator and the

DATA indicator below it on the operation panel are neither lit nor
blinking.

1)

Turn the power switch located on the operation panel to the
"OFF" position.

2)

After checking that the operation panel has gone out, open the
front cabinet and turn the main power switch to the “OFF” posi-
tion.

3)

Disconnect the power plug of the main unit from the power out-
let.

1)

Remove the screw of right rear cabinet, push down the right
rear cabinet. Disengage the pawls, and remove the right rear
cabinet so that slide to the front side.

2)

Remove the screws of control box. Raise the finger handle,
and pull out the control box slowly.

3)

Pull out the control box until the position in which the clamp is
seen. Remove the HDD-IDE cable from the clamp.

4)

Pull out the control box until the position in which the connector
of the HDD-IDE cable is seen. Pull the sheet, and remove the
HDD-IDE cable.