Read Sharp MX-PEX1 (serv.man3) Service Manual online
81
Clearing the CMOS and power-up settings
Clearing the CMOS and power-up settings
Use the following procedure to clear the CMOS and power-up settings for the
Fiery X3eTY2, as a final troubleshooting step before you decide to replace the
motherboard.
Fiery X3eTY2, as a final troubleshooting step before you decide to replace the
motherboard.
T
O
CLEAR
THE
CMOS
AND
POWER
-
UP
SETTINGS
1.
Make sure that the Fiery X3eTY2 is powered off, and remove the power cable from
the system.
the system.
2.
Access and open the Fiery X3eTY2 (see page 6).
3.
Remove the battery from the motherboard (see page 16).
Set aside the battery so that you can replace it later.
4.
Reset the CMOS jumper setting (see Figure AA).
Locate the jumper that is installed on JP1 near the PRI-IDE connector on the
motherboard. Remove the jumper and install it on pins 2 and 3. Wait one full minute.
Then remove the jumper and reinstall it on pins 1 and 2.
motherboard. Remove the jumper and install it on pins 2 and 3. Wait one full minute.
Then remove the jumper and reinstall it on pins 1 and 2.
F
IGURE
AA
CMOS jumper pins
5.
Reinstall the battery.
6.
Reassemble the Fiery X3eTY2 (see page 36).
7.
Power on the Fiery X3eTY2, and configure the date and time in Setup.
For more information, see Configuration and Setup on the User Documentation CD.
1
2
3
JP1
PRI-IDE
Click on the first or last page to see other MX-PEX1 (serv.man3) service manuals if exist.