Read Sharp MX-PE10 FIERY (serv.man39) Technical Bulletin online
9
Installing the 64-bit Fiery Server printer driver on a 32-bit Windows
Server 2008 computer
Server 2008 computer
This procedure assumes that the user has already installed the 32-bit version of the Fiery
Server printer driver successfully on the Windows Server 2008 computer, and needs to add
the 64-bit version for Point and Print purposes. The process requires the user to have access to
a emote 64-bit Windows Server 2008 computer.
Server printer driver successfully on the Windows Server 2008 computer, and needs to add
the 64-bit version for Point and Print purposes. The process requires the user to have access to
a emote 64-bit Windows Server 2008 computer.
T
O
ADD
THE
64-
BIT
PRINTER
DRIVER
TO
A
32-
BIT
W
INDOWS
S
ERVER
2008
COMPUTER
1 Log on as Administrator to the remote 64-bit Windows Server 2008 computer.
2 Go to [Windows]\System32 folder on the remote 64-bit Windows Server 2008 computer and
make that folder shared.
3 Get the external IP address of the remote 64-bit Windows Server 2008 computer and record it
somewhere. You are going to need this when installing the additional driver.
4 Lo on as the Administrator to the 32-bit Windows Server 2008 computer (your host).
5 Go to Control Panel > Printers and select Server Properties on the host system.
6 Select Drivers tab.
The driver that you have installed with “x86” under the Processor column should be listed.
7 Click Add.
8 Select the additional driver you want to install, and then click Next.
In this case, it will be “x64 Type 3 - User Mode”.
9 Click Have Disk and point to the “oemsetup.inf” of the Fiery Server printer driver.
10 Select the Fiery Server printer driver and click Next.
11 Click Finish.
12 After step
9
another screen will pop-up with “Please provide a printer driver”. Once again
select the “oemsetup.inf” that you selected in Step
8
.
13 Provide a path to Windows Media (x64 Processor). Click Browse and browse to \\[IP ADDRESS
OF WINDOWS 2008 SERVER 64-bit remote computer] and press Enter.
Because you have initially shared the “Windows\System32” folder of this remote computer
you will get access to folder “System32”.
you will get access to folder “System32”.
14 Go to “system32\driverstore\FileRepository\ntprint.inf_xxxxx” folder, where “xxxxx” can be
any length of any letters and numbers depending on your system. The key here is to select
the folder that starts with “ntprint.inf_”.
the folder that starts with “ntprint.inf_”.
15 Select “ntprint.inf” file and then click OK.
Installation should continue and the 64-bit version of the Fiery Server printer driver will be
installed on your system.
installed on your system.
You can take the sharing off from Windows\System32 folder on the remote 64-bit computer.
Click on the first or last page to see other MX-PE10 FIERY (serv.man39) service manuals if exist.