MX-M850 (serv.man37). Section 7 Simulation - Sharp Copying Equipment Service Manual (repair manual). Page 8

MX-M1100  SIMULATION  7 – 8

66

29

Used to clear the data related to the address book (one-touch registration, FTP/ Desktop 
extension, group extension, program registration, interface memory box, meta data, Inbound 
Routing, Document Admin table).

Data clear

30

Used to check a change in the TEL/LIU status.

FAX

Operation test, check

31

Used to set the TEL/LIU output port.

FAX

Operation check

32

Used to check the received data (fixed data) from the line.

FAX

Operation test, check

33

Used to detect the line signals (BUSY TONE/CNG/CED/FNET/DTMF).

FAX

Operation test, check

34

Used to measure the communication time of the send test image data. 

FAX

Operation test, check

36

Used to perform the interface check between the MFP controller and the MDMC. 
(Data line or command line check)

FAX

Operation test, check

39

Used to set the destination.

FAX

Setting

42

Used to rewrite the power control program again to the FAX BOX.

FAX

Setting

43

Used to write the adjustment value of the power control program to the FAX BOX.

FAX

Setting

60

Used to register the ACR data.  When calling, the carrier prefix is added to the dial number to 
provide the auto select function of low-price line to the user. * To use this simulation, the FAX soft 
SW 24-4 and 24-5 must be set to [FUNCTION ON] and [Register Enable]. 

Adjustment/ Setting

67

24

Used to set for auto color calibration. For FIERY option support, Sim  is not displayed.

Adjustment/ Setting

25

Used to set the printer engine color balance manual correction. For FIERY option support, the 
Sim is not displayed.

Adjustment/ Setting

27

Used to register the scanner target value of the printer engine auto density adjustment. For 
FIERY option support, this Sim is not displayed.

Adjustment/ Setting

28

Used to reset the printer engine auto adjustment scanner target value to the default value.

Adjustment/ Setting

31

Used to clear the printer calibration value. For FIERY option support, the Sim is not displayed.

Data clear

32

Printer screen gamma table setting (300/600DPI). When supporting the FIERY option, Sim is not 
displayed.

Adjustment/ Setting

33

Used to perform the gamma correction of printer screens (for PCL). For FIERY option support, 
the Sim is not displayed.

Adjustment/ Setting

34

Used to set Enable/Disable of the printer half-tone max. density correction.

Adjustment/ Setting