MX-M700U (serv.man3). Installation Manual - Sharp Copying Equipment Service Manual (repair manual). Page 13

AR-M550/M620/M700  INSTALLATION MANUAL  (AR-M550/M620/M700)  1 - 12

Check the following contents. For adjustment and check procedures,
refer to the chapter of adjustments.

Use SIM 26 to set the customer's desired specifications.

Use SIM 22-6 to print and keep the various setting and adjustment
data (list).

When a memory trouble occurs, or when the PCU PWB or the ICU
PWB is replaced, if the above information is not available, all the
adjustment must be performed from the beginning again.

If the above information is available, however, directly enter the setting
and adjustment values for efficient servicing.

When moving the copier, turn off the power and perform the following
works.

1) Remove the paper from the paper tray.

2) Remove the developing unit from the main unit.

3) Lock the position which was released at installation (see the page

1-5).

4) Remove the adjuster cover, and raise the adjuster (see the page 1-

5).

Note: Since the main unit includes the hard disk drive, be careful not

to apply vibrations and shocks during transit.

Sim No.

Content

26

2

Used to set the paper size of the tray 2 and the large 
capacity tray. (When the paper size is changed, this 
simulation must be used to change the paper size by 
software.)

5

A3 paper 1 count/2 count setting
Used to set the count mode of the total counter, the 
developer counter, and the maintenance counter.

6

Specifications depending on the destination

18

Used to set YES/NO of toner save operation. (This 
function is valid only in Japan and UK versions.)

35

Used to set whether the trouble history is displayed as 
one time trouble or the number of times of trouble.