Read Sharp MX-M364N / MX-565N (serv.man4) Service Manual online
MX-M565N ADJUSTMENTS AND SETTINGS 4 – 11
RV: REAR VOID AREA
FV: FRONT VOID AREA
RV + FV 4.0mm
RV = 2.0 ±2.0mm
FV = 2.0 ±2.0mm
If the above requirement is not met, do the following steps.
6)
Change the adjustment value.
Enter the adjustment value and press the [OK] key or the
[EXECUTE] key.
[EXECUTE] key.
When [EXECUTE] key is pressed, the adjustment pattern is
printed. When the adjustment value is increased, the adjust-
ment pattern is shifted to the front frame side. When it is
decreased, the adjustment pattern is shifted to the rear frame
side. When the set value is changed by 1, the shift distance is
changed by about 0.1mm. Repeat procedures 3) - 6) until the
conditions of procedure 5) are satisfied. In case a satisfactory
result cannot be obtained by repeating the above procedures,
perform the following procedure.
printed. When the adjustment value is increased, the adjust-
ment pattern is shifted to the front frame side. When it is
decreased, the adjustment pattern is shifted to the rear frame
side. When the set value is changed by 1, the shift distance is
changed by about 0.1mm. Repeat procedures 3) - 6) until the
conditions of procedure 5) are satisfied. In case a satisfactory
result cannot be obtained by repeating the above procedures,
perform the following procedure.
7)
Loosen the paper feed tray off-center adjustment screws (2
pcs.) at the center section of the lift plate of the paper feed tray,
and change the gear unit position in the front/rear frame direc-
tion. Repeat the adjustment procedures from 4).
pcs.) at the center section of the lift plate of the paper feed tray,
and change the gear unit position in the front/rear frame direc-
tion. Repeat the adjustment procedures from 4).
ADJ 4
Scan image distortion
adjustment (OC mode)
adjustment (OC mode)
This adjustment is needed in the following situations:
* When the scanner (reading) section is disassembled.
* When the copy image is distorted.
4-A
Scanner (reading) unit parallelism
adjustment
adjustment
Before execution of this adjustment, remove the document table
glass.
glass.
1)
Remove the LED lamp unit, and then loosen the screws which
are fixing the scanner unit A and the drive wire. Release the
scanner unit A from the drive wire.
are fixing the scanner unit A and the drive wire. Release the
scanner unit A from the drive wire.
2)
Turn the scanner drive pulley manually and shift the scanner
unit B to bring it into contact with the stopper.
unit B to bring it into contact with the stopper.
When the scanner unit B is in contact with the two stoppers on
the front and the rear frames simultaneously, the parallelism is
proper.
the front and the rear frames simultaneously, the parallelism is
proper.
If this requirement is not met, do the following steps.
RV
2.0mm
2.0mm
2.0mm
FV
2.0mm
2.0mm
2.0mm
Click on the first or last page to see other MX-M364N / MX-565N (serv.man4) service manuals if exist.