Read Sharp MX-M364N / MX-565N (serv.man37) Technical Bulletin online
Sharp Electronics (UK) Ltd., Technical Services Group
2.
Installation procedure pf Process sensor cover sheet
Fold the sheet along the slit at a
90-degree angle so that the
double-faced tape section is
facing inwards.
90-degree angle so that the
double-faced tape section is
facing inwards.
Fold the sheet along the
slit.
slit.
After folding, remove all back
sheets.
sheets.
<NOTE> Clean the sensor lens
surface with air or dry cloth to
remove foreign materials like
toner, etc.
surface with air or dry cloth to
remove foreign materials like
toner, etc.
Insert the sheet from the top up to the
place surface while adjusting the folding
line of the sheet and the angle of the
sensor.
place surface while adjusting the folding
line of the sheet and the angle of the
sensor.
Check that the attached surfaced is not
lifted.
lifted.
Attach the sheet while tightly
holding the red section in the
picture.
holding the red section in the
picture.
Attach the sheet while tightly
holding the red section in the
picture. After attaching the
sheet, check that the sheet
does not run off the plate.
holding the red section in the
picture. After attaching the
sheet, check that the sheet
does not run off the plate.
Process control
sensor PWB
sensor PWB
①
②
③
④
⑤
Click on the first or last page to see other MX-M364N / MX-565N (serv.man37) service manuals if exist.