Read Sharp MX-M363N / MX-M363U / MX-M503N / MX-M503U (serv.man18) Service Manual online
MX-M503N Dehumidifying heater 27 – 4
4)
Attach the core (This procedure only applies to the 230V
series).
Attach the AC-cable connection plate (only for 120V series), or
attach the inlet mounting plate (only for 230V series). Secure it
with screw.
series).
Attach the AC-cable connection plate (only for 120V series), or
attach the inlet mounting plate (only for 230V series). Secure it
with screw.
NOTE: When installing, be careful to biting the wire.
D. Installation of the rear cabinet and the left rear
lower cabinet
1)
Install the left rear lower cabinet and secure it with the screw.
2)
Install the rear cabinet and secure it with the screw.
E. Installation of the scanner heater kit
(1) Assembling of the scanner heater unit
1)
Secure the marking position on the harness of the scanner
heater (package part No.13) to the heater fixing plate (package
part No.14) with the banding band (package part No.15).
heater (package part No.13) to the heater fixing plate (package
part No.14) with the banding band (package part No.15).
2)
Extend the harness, and secure the other position of it with
banding band (packing part No.15).
banding band (packing part No.15).
3)
Tighten the snap band and cut its tip to approx. 5 mm or less.
Slide the banding band head to the square hole (Part that is
enclosed by the mark).
Slide the banding band head to the square hole (Part that is
enclosed by the mark).
NOTE: The banding band head and cut tip must not protrude
behind the heater fixing plate.
120V Series
230V Series
1
2
Click on the first or last page to see other MX-M363N / MX-M363U / MX-M503N / MX-M503U (serv.man18) service manuals if exist.