MX-M350N, MX-M350U, MX-M450N, MX-M450U (serv.man9). Machine Operations - Sharp Copying Equipment Service Manual (repair manual). Page 4

MX-M350/M450 N/U  MACHINE OPERATION  10 - 4

These programs are used to adjust the settings of various printer
functions.

This program is used to disable notice page printing.

Normally this program is set to not print a notice page.

This program is used to adjust the lightness or darkness of prints.

Five levels are provided for density adjustment. These are repre-
sented by numbers displayed on the touch panel. Among the dis-
played numbers, a smaller value indicates lighter density and a
larger value indicates a darker density.

This program is used to disable test page printing.

When the program is turned on, the PRINTER TEST PAGE in the
custom settings cannot be printed.

If this program is set, and printing onto 8-1/2" x 11" size paper is
selected but not available, the printer will automatically substitute
A4 size paper in place of 8-1/2" x 11" paper if A4 paper is avail-
able.

∗

8-1/2" x 11" paper cannot be automatically selected in place of
A4.

NOTE: When 8-1/2" x 11" size is specified for a document

attached to an E-mail that has been transmitted from a
foreign country and A4 size paper is not installed in the
printer, printing cannot be done without operator
intervention. If this program is set, printing will be
executed without intervention if a paper tray is loaded with
A4 paper.

These programs are used to control data transmitted to the paral-
lel port, USB port or network port of this printer.

This program is used to output the print data from a computer in
the hexadecimal dump format with corresponding characters
(ASCII). This program is used to check proper transmission of
print data from the computer to the printer.

Output example of hexadecimal dump mode

This program is used to set the length of time to wait for an I/O to
complete a job on the parallel port or the network port. If the data
stream to the port does not transmit data for a length of time
exceeding the timeout, the job will cancel and the next job will start
processing.

The I/O timeout setting is used to set the amount of time after
which an I/O timeout will occur when waiting for print data.

Default setting: 20 seconds

NOTE: The allowable range of the time is 1 to 999 seconds.

This program is used to enable or disable printing from the USB
port.

Default setting: Enable

If the machine is connected using the USB port, select the emu-
lated printer language.

The setting items are the same as those of "Parallel port emulation
switching".

NOTE: It is recommended to set "AUTO" (default setting) unless

an error due to this setting occurs frequently.

This program is used to enable or disable printing from the net-
work port.

Default setting: Enable

DEFAULT SETTINGS

INTERFACE SETTINGS

PROHIBIT NOTICE PAGE PRINTING

PRINT DENSITY LEVEL

PROHIBIT TEST PAGE PRINTING

A4/LETTER SIZE AUTO CHANGE

HEXADECIMAL DUMP MODE

I/O TIMEOUT

ENABLE USB PORT

USB PORT EMULATION SWITCHING

ENABLE NETWORK PORT

NETWORK PORT EMULATION SWITCHING

PORT SWITCHING METHOD

IP ADDRESS SETTING

ENABLE TCP/IP

ENABLE NetWare

ENABLE EtherTalk

ENABLE NetBEUI

RESET THE NIC

TANDEM SETTING

PING COMMAND

PRINTER SETTINGS

NETWORK SETTINGS

Level 2

Level 1

Level 3

Administrator password