MX-M350N, MX-M350U, MX-M450N, MX-M450U (serv.man20). Software Setup Guide - Sharp Copying Equipment User Guide / Operation Manual. Page 9

To connect the machine to a network, connect the LAN cable to the 
machine's network connector. (On the MX-M350U/M450U, the 
network expansion kit is required.) Use a shielded LAN cable.

Before installing the software, check with the administrator of the machine to make sure that the machine is connected 
to the network and network settings such as the IP address have been configured. (The factory default setting for the IP 
address is to receive the IP address automatically when the machine is used in a DHCP environment.)
Network settings can be configured using "Network settings" in the administrator settings on the machine. 

You can check the IP address of the machine by printing out the "All custom setting list" in the system settings. Follow 
these steps to print out the "All custom setting list".
Press the [SYSTEM SETTINGS] key, touch the [LIST PRINT] key, and then touch the [ALL CUSTOM SETTING LIST] 
key.

The machine can be connected to a computer using a USB cable if the computer is a Windows computer. (The USB 
interface on the machine cannot be used in a Macintosh environment.)
The machine and computer should be connected while the printer driver is being installed. If a USB cable is connected 
before the printer driver is installed, the printer driver will not be installed correctly. For the procedure for connecting a 
USB cable, see "WHEN THE MACHINE WILL BE CONNECTED WITH A USB CABLE" (page 15).

• If the machine is used in a DHCP environment, the IP address of the machine may change. If this happens, printing will not 

be possible. This problem can be avoided by using a WINS server or by assigning a permanent IP address to the machine.

• This manual explains how to set up the software in a Windows network environment and in a Macintosh network 

environment.

01_Setup.fm  7 ページ  ２００６年１２月１２日　火曜日　午後７時５７分