Read Sharp MX-M266N / MX-M316N / MX-M356N Handy Guide online
SHARP
IMAGE SEND COMMUNICATION ERROR CODES
43
Report Code
(Result)
Result Displayed
Communication Interruption Content
95
NG95 XXXX *1
When the path is too long in execution of Scan To USB.
96
NG96 XXXX *1
When the normal process is not executed in the secure mail sending.
98
NG98 XXXX *1
The copy inhibit pattern is detected when scanning a document.
99
NG99 XXXX *1
A document which is inhibited to be copied such as a banknote is scanned.
*1
For a job status result in "Display in the column of result, NG XXXX is displayed, is the code
number. For a communication result, Communication error
(XXXX) is displayed.
*2
The error code of Scan To USB is specified only in the job log.
*
When the communication result is OK, the communication sub code 1 and the communication sub
code 2 are 0000. Errors in ( ) are not used.
code 2 are 0000. Errors in ( ) are not used.
COMMUNICATION REPORT SUB CODE 1:
The communication report sub code 1 (upper 2 digits) are always indicated as 00.
COMMUNICATION REPORT SUB CODE 2:‐
The communication report sub code 1 (upper 2 digits) are always indicated as 00.
COMMUNICATION REPORT SUB CODE 2:‐
Report Code 2
Communication Interruption Content
Send / Receive
00
When the conditions after 01 do not apply.
Send/Receive
01
Send length over
Send
02
EOL time up
Receive
03
Carrier detection time up
Receive
04
Time up of the communication start command from the machine side
Receive
05
Time up in phase C (8 min)
Send
06
Memory image decode error
Receive
07
Memory image decode error
Send
08
Time up between frames in phase C (Report code is 0 or 16.)
Send/Receive
09
Not used
—
10
Not used
—
11
Polarity reversion detection
Receive
12
Invalid command reception
Receive
13
Time up (1‐minute timer/6‐second time)
Receive
14
PUT error
Receive
15
In V.34 mode, time up is generated when shifting from Primary to Control.
Receive
16
In V.34 mode, time up is generated when shifting from Control to Primary.
Receive
17
Command receive time‐up from MFP controller
Receive
18
Not used
—
19
Not used
—
20
Polarity reversion detection
Send
21
Invalid command reception
Send
22
Fall‐back retry number over
Send
23
Command retry number resend over
Send
24
Time up (T5 timer)
Send
25
Time up (T5 timer) in V.34 mode
Send
26
In V.34 mode, time up is generated when shifting from Primary to Control.
Send
27
In V.34 mode, time up is generated when shifting from Control to Primary.
Send
28
When sending the FSK signal, no response of send completion is sent back from
the MODEM chip within a certain time. (V.34, other than V.34)
Send
Click on the first or last page to see other MX-M266N / MX-M316N / MX-M356N service manuals if exist.