Read Sharp MX-M266N / MX-M316N / MX-M356N (serv.man5) Service Manual online
MX-M314N MX-TR18 (JOB SEPARATOR) 9 – 2
6) Disengage the pawls and remove the paper exit dummy cover.
7)
Remove the paper holding arm, install it to job separator AS.
(Same as the current state)
(Same as the current state)
8) Remove the current the second paper exit right door unit and fix
the bundled second paper exit right door unit to the right cabinet
middle unit.
middle unit.
9) Install the job separator tray AS.
10) Install the rail dummy cover part to the guide rail so that slide
the over part from front side to rear side.
After that, insert the rib of tray part to the location of insertion of
the second paper exit tray holder.
Check that it is caught while being pushing up the tray.
After that, insert the rib of tray part to the location of insertion of
the second paper exit tray holder.
Check that it is caught while being pushing up the tray.
11) Install the right cabinet middle and the right cover bottom.
12) Install the rear cabinet.
13) Job separator setting in simulation 26-1.
Paper holding arm
Click on the first or last page to see other MX-M266N / MX-M316N / MX-M356N (serv.man5) service manuals if exist.