MX-M266N, MX-M316N, MX-M356N (serv.man4). NOTE Installation Manual for models with the V suffix. - Sharp Copying Equipment Service Manual (repair manual). Page 69

MX-M356NV  Dehumidifying heater kit  23 – 6

2)

Remove two screws from the scanner bottom.

3)

Connect the harness of the scanner heater. Attach the scanner
heater unit, and fixing the screw (M3 x 4 Round-tipped).

4)

Attach the scanner heater and secure it with the screw (M4 x 6
Bind machine screw). Pass the harness through the clamp.

NOTE: The convex part of the scanner heater must be

inserted into the hole of the scanner frame.

5)

Tighten the loose scanner heater harness by pulling it in the
arrow direction and secure it with the snap band then cut its tip
to approx. 5 mm or less.

6)

Move the lamp unit by hand and check that it move smoothly in
all movable area.

NOTE: Check that there is no interference of the harness of

the scanner heater in the wire and the 2/3 mirror unit.

1)

Attach the SPF glass and the table glass. Attach the glass
holder.

NOTE: When installing the glass holder, slide it to the left until it

clicks, and fix it with screws.

1)

Turn on the dehumidifier heater switch.

2)

Measure the resistance value between the earth terminal and
the AC terminal (L side), and between the earth terminal and
AC terminal (N side) with the circuit tester, and confirm they
are not short-circuited.

3)

When not using the dehumidifier heater after checking, turn off
the dehumidifier heater switch.