Read Sharp MX-M202D (serv.man3) Handy Guide online
Coin Vend Interface
13
Document Solutions After Sales Service
The coin vend interface for the MX-M182D/202D/232D machines is located on the MCU PWB.
Before connecting a third party auditor, the device must conform to the following specifications:
1. The auditor interface should be optically isolated from the copier.
2. The external auditor interface should be ‘Power Supply Unit’ independent.
3. supply.
4. The external auditing device’s plug-top adapter should have a reinforced insulation
2. The external auditor interface should be ‘Power Supply Unit’ independent.
3. supply.
4. The external auditing device’s plug-top adapter should have a reinforced insulation
barrier.
5. The external auditing device must ‘hold’ a CE mark.
To enable coin vend function, execute Simulation 26-03 and select Vendor Control (set value to
1).
During duplex copy mode, the interface will issue 2 billing pulses for each duplex copy
irrespective of the size of the paper used (e.g. an A4 duplex copy will generate 2 billing pulses
and an A3 duplex copy will also generate 2 billing pulses). In order for the external auditing
device to detect the selected paper size, the paper size outputs on pin’s 1 to 4 must also be
used.
Note: The configuration of the external auditor connector (CN133) may differ slightly from that of
other models, so it is important to ensure that the correct cable/connections are used.
1).
During duplex copy mode, the interface will issue 2 billing pulses for each duplex copy
irrespective of the size of the paper used (e.g. an A4 duplex copy will generate 2 billing pulses
and an A3 duplex copy will also generate 2 billing pulses). In order for the external auditing
device to detect the selected paper size, the paper size outputs on pin’s 1 to 4 must also be
used.
Note: The configuration of the external auditor connector (CN133) may differ slightly from that of
other models, so it is important to ensure that the correct cable/connections are used.
Connector Signals
Pin No
Signal Name
Details
1
+24 V dc
2 P-GND
3
+24 V dc
4 GND
5
/CV_COUNT
Paper exit copy signal (Late billing pulse)
6 /CV_COPY
Enables
ready status of copier
7 /CV_START
Copy start paper feed clutch signal (Early billing
pulse)
8 /AUD_PNC
9 /CV_CA
Clear-all
Signal
10 /AUD_COPY
11 /CV_DPX
Duplex
signal
12 /AUD_CA
13
/CV_SIZE0
Copy paper size indicator
14 /AUD_READY
15
/CV_SIZE1
Copy paper size indicator
16 /AUD
17
/CV_SIZE2
Copy paper size indicator
18 /PNC_a
19
/CV_SIZE3
Copy paper size indicator
20 GND
Click on the first or last page to see other MX-M202D (serv.man3) service manuals if exist.