MX-M160, MX-M160D, MX-M160DK (serv.man2). Service Manual. - Sharp Copying Equipment Service Manual (repair manual). Page 107

Read Sharp MX-M160 / MX-M160D / MX-M160DK (serv.man2) Service Manual online

MX-M200D FLASH ROM VERSION UP PROCEDURE 12-3
8) PC side:
 
Specify the download file (*.dwl).
9) PC side: 
 
The download file is specified, download is automatically performed.
 
The AUTO PAPER SELECT indicator and START indicator will blink 
approximately 15 seconds after the download file is specified.
10) PC side:
 
When the message below is displayed, download is completed.
 
Completion message: DOWNLOAD COMPLETED
NOTE (Important):
•Be sure that the power is not turned off and the USB cable is not 
removed until the word "OFF" appears.
11) Main body side: 
 
Wait until the word "OFF" appears on the operation panel. 
 
The appearance of "OFF" indicates the completion of the download 
(writing into ROM). 
 
Turn the power off.
12) After-process: Terminate the maintenance program, and turn on the 
power of the main body.
After the download (data transmission) has been completed, exit the 
software program. The USB cable can be removed at this point.
NOTE:
•For making a second connection with another machine, select the "File" 
and "Reconnect" in the menu bar on the maintenance program at the 
time of the USB being re-connected. Repeat the previous procedures 
from the above 5).
* Forbidden actions while downloading (Important)
Failure in the download concerned may not allow you to conduct the 
subsequent download procedures. Added care should be taken to avoid 
having the situation below arise while downloading.
•Switching off the main body.
•Disconnecting the download cable (USB cable).
* If the above inhibit item occurs during downloading:
Turn OFF and ON the power. 
1)  If "d" (which means downloading) is displayed on the operation 
panel LED of the machine, perform downloading again. 
2)  If "d" (which means downloading) is not displayed on the operation 
panel LED of the machine, turn OFF the power, and press and hold 
the [Copy ratio display] key and the [PAPER SELECT] key and turn 
ON the power. If, then, "d" (which means downloading) is displayed 
on the operation panel LED of the machine, perform downloading 
again. 
 
If "d" is still not displayed, the MCU must be replaced.
Page of 121
Display

Click on the first or last page to see other MX-M160 / MX-M160D / MX-M160DK (serv.man2) service manuals if exist.