Read Sharp MX-GB50A (serv.man2) Service Manual online
Sharp SmartPunch Pro Installation Manual
3
1 Recommendations and Pre-requisites
•
You will need the installation kit provided with the SmartPunch Pro unit, which can be found in the
main carton.
main carton.
2 Unpacking
•
Inspect the outside of the package for shipping damage. If there is evidence of shipping damage,
contact the shipping carrier immediately.
contact the shipping carrier immediately.
•
Remove the punch from its shipping carton. Three people are recommended, one lifting at the
casters while two lift at the top cover. DO NOT lift using the front door panel.
casters while two lift at the top cover. DO NOT lift using the front door panel.
•
Retain the smaller accessory box; it contains parts required for correct installation of the
SmartPunch Pro.
SmartPunch Pro.
•
Inspect for any concealed damage to the unit. If there is evidence of concealed shipping damage,
contact the shipping carrier immediately.
contact the shipping carrier immediately.
•
Remove all shipping tape from doors and levers.
3 Cable Connections and Paper guides
Review the table below to identify which section of the guide to refer to install the SmartPunch Pro
Section
Device upstream to SmartPunch Pro
3.1
MX-CF11 Inserter (or) MX-ST10 High Capacity Stacker
3.2
MX-RB18 Curl correction unit
3.1
Cable connections
a) Remove the finisher rear cover and plug the 7 pin communication cable to CN145 on the
finisher board. The communication cable is provided in the Installation kit of SmartPunch Pro.
(Finisher to SmartPunch Pro cable P/N OPT7712585)
GBC will update
this with a new
picture showing
IF bracket
this with a new
picture showing
IF bracket
Click on the first or last page to see other MX-GB50A (serv.man2) service manuals if exist.