Read Sharp MX-FNX8 Service Manual online
MX-FNX8 REPLACEMENT AND ADJUSTMENT 3 – 3
* Right side in the figure is [+] side, and the left side [–].
14) Open the front door of the finisher, and pull out the center bind-
ing staple unit.
15) Open the open/close guide plate.
16) Turn the adjustment screw according to the measured shift
16) Turn the adjustment screw according to the measured shift
quantity in the ratio of 0.1mm/1 scale. If the shift quantity is [+],
turn it clockwise. If the shift quantity is [–], turn it counterclock-
wise.
turn it clockwise. If the shift quantity is [–], turn it counterclock-
wise.
17) Lift the adjustment screw upward, and let it fall by its own
weight.
18) Securely tighten the fixing screw which was loosened.
B. FOLD VERTICAL SKEW ADJUSTMENT
Important
• The fold unit is adjusted for optimum performance before the fin-
• The fold unit is adjusted for optimum performance before the fin-
isher is shipped from the factory. Do this adjustment only if the
edges of folded booklets are not even.
edges of folded booklets are not even.
1)
Set A3 paper (any paper other than black background) on the
DSPF.
DSPF.
2)
Set the staple position to the center binding.
(Do not select the image edit.)
(Do not select the image edit.)
3)
Press the copy start button, and perform center binding of one
set only.
set only.
4)
Draw an arrow mark on the paper discharged to the center
binding tray.
binding tray.
5)
Measure the shift quantity of the upper edge from the lower
edge at the center of the rear edge as shown below.
edge at the center of the rear edge as shown below.
6)
Turn on the main power switch.
7)
Press [SYSTEM SETTING] key on the operation panel and log
in as the administrator.
(Password: admin/default)
in as the administrator.
(Password: admin/default)
8)
Press [Administrator Adjustment] key and select [Option
Adjustment] on the administrator adjustment menu.
Adjustment] on the administrator adjustment menu.
9)
Select [Saddle Unit] from the option adjustment menu.
10) Adjust the center folding position. (Select the paper size mea-
sured in the procedure 5).
11) After execution of the adjustment, repeat the procedures of 1) -
5). If there is no problem, terminate the adjustment.
If any more adjustment is required, repeat the procedures of 6)
- 10).
If any more adjustment is required, repeat the procedures of 6)
- 10).
Fixing screw
Adjustment screw
Open/close
guide plate
guide plate
Center binding
staple unit
staple unit
Click on the first or last page to see other MX-FNX8 service manuals if exist.