Read Sharp MX-FNX5 (serv.man3) Service Manual online
MX-FNX5 REPLACEMENT AND ADJUSTMENT 3 – 10
7. PUNCH UNIT
A. PUNCH POSITION ADJUSTMENT
• The position of the punched holes can be adjusted in two ways.
(1) Front to Rear Adjustment
Three spacers [A] are provided with the punch unit for manual
adjustment of the hole position in the main scan direction:
• 2 mm (x 1)
• 1 mm (x 2)
adjustment of the hole position in the main scan direction:
• 2 mm (x 1)
• 1 mm (x 2)
NOTE:
One spacer was installed at installation and the remaining spac-
ers were fastened with a screw to the rear frame of the finisher
under the rear cover and slightly above the lock bar.
One spacer was installed at installation and the remaining spac-
ers were fastened with a screw to the rear frame of the finisher
under the rear cover and slightly above the lock bar.
8. SHIFT TRAY JOGGER UNIT
A. SHIFT TRAY JOGGER UNIT
1)
Remove the jogger unit cover [A] ( x 2).
* Apply grease to the jogger slide part at every 500K.
(Silicon oil : ZSOLVZZL006FC)
2)
Remove the jogger unit [B] ( x 2,
x 1).
B. SHIFT TRAY JOGGER UNIT PCB
1)
Remove the jogger unit from the finisher. (
8. SHIFT
TRAY JOGGER UNIT -A.)
2)
Remove the jogger unit control PCB [A] ( x 2,
x 3)
C. SHIFT TRAY JOGGER UNIT MOTORS
1)
Remove the jogger unit from the finisher. (
8. SHIFT
TRAY JOGGER UNIT -A.)
2)
Remove the shift tray jogger motor [A] ( x 2,
x 1).
3)
Remove the shift tray jogger retraction motor [B]
( x 2,
( x 2,
x 1).
[A]
[A]
*Apply grease
[B]
[A]
[A]
[B]
Click on the first or last page to see other MX-FNX5 (serv.man3) service manuals if exist.